Whats the best way to keep a mining rig cool? Inline fans and flexible ductwork can make a very efficient cooling solution for most mining rigs as ac units should be considered costly in most cases.
A good mining rig should hold a steady temperature within the 60-70c range. Follow the steps listed down below for efficiently cooling your miners. If you are just a hobbyist miner, you dont have to be critical of cooling techniques. Most hobbyists use some gpu mining rigs instead of asic ones.
A pair of smart bitcoin miners has built an amazing 120,000 mining rig with one incredible unorthodox twist its submerged in a vat of cooling oil.
Therefore, there are three quick cooling methods as follows. At present, the water cooling and oil cooling systems have been tested. Its a way to achieve a cooling effect by directly contacting the miner with coolant. Apart from reducing temperature, there is no noise generated by the fans.
Therefore, it is vital to avoid choosing an underperforming fan that can result in your gpus overheating from trapped hot air or clogged dust. The cooling effect is essential, especially when running more gpus. In selecting the perfect fan, you need to do your homework first.
just a quick update on the cooling boxes for my mining rigs - 2 months after my 1st video.
in this video we go over future plans as we expand our little mining rig setup. I know we only started a few weeks ago, but we are already discussing more g.
this allows you to remove the limiter and run your mining rig at a higher overclock speed, if you so wish. In doing so, its believed you can get up to about 20 more hashpower. Obviously, this isnt recommended by the manufacturer, but i do it, and i have had no issues.
an essential factor in any type of mining rig, cooling is going to ensure that your device works properly and prevents any type of possible overheating. Dont be cheap and invest in the best cooling possible - its always better to be safe than sorry.
it wouldnt be the coldest watercooling loop, but itd be fine for mining if flow rates are reasonable. For a fabricator, it could be a couple weekends of work to get a dozen miners swapped over to water, and cooled through a car radiator. Materials only, 10 rigs may cost 1000 for all the parts and metal stock, much of that being cost of the pumps.